Publicidad
Idiomas disponibles
Idiomas disponibles
CRX1050 – CRX1140
Condensate is produced when the refrigerator is operating normally. You
can either wipe up the condensate in regular intervals, or drain it through
an outlet in the rear of the refrigerator.
Proceed as follows to install the refrigerator:
➤ If you wish to drain the condensate through a hose:
Remove the drain plug (fig. 9 1, page 7).
➤ Connect a hose with an inside diameter of 10 mm to the outlet port
(fig. 9 2, page 7).
➤ Undo the transport lock (chapter "Releasing the lock" on page 27).
➤ Open the refrigerator door.
➤ Remove the blanking plugs (fig. 0 2, page 7).
➤ Push the refrigerator into the recess.
➤ Fix the refrigerator in place using suitable screws (fig. 0 1, page 7).
➤ Press the blanking plugs (fig. 0 2, page 7) into the openings.
7.3
Changing the door hinge
You can also change the hinge of the door, so that it opens to the left rather
than the right.
➤ Proceed as shown in fig. a, page 8 to fig. c, page 8, to change the
hinges.
7.4
Connecting the refrigerator
Connecting the refrigerator to DC voltage
A
NOTICE!
To avoid voltage drops and loss of performance, keep the
connection cable as short as possible and not be interrupted.
Therefore avoid additional switches, plugs or power strips.
Disconnect the cooling device and other electric consumers
from the battery before you connect the battery to a quick
charging device. Overvoltage can damage the electronics of
the device.
The refrigerator can be operated with a 12 V or a 24 V DC voltage supply.
EN
Installing and connecting the refrigerator
21
Publicidad
