Publicidad
Idiomas disponibles
Idiomas disponibles
CRX1050 – CRX1140
Connecting the refrigerator to AC voltage
D
DANGER! mortal danger!
Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
If you are operating your refrigerator on board a boat with an
AC mains connection using a shore connection, you must
install a residual current circuit breaker between the AC mains
supply and the refrigerator.
Seek advice from a trained technician.
Proceed as follows when you connect the refrigerator to the AC supply:
➤ Plug the connector into the AC socket (fig. f 1, page 9).
8
Using the refrigerator
I
NOTE
Before starting your new refrigerator for the first time, you
should clean it inside and outside with a damp cloth for
hygienic reasons (please also refer to the chapter "Cleaning
and maintenance" on page 28).
Do not use force to press the flap of the freezer.
Do not pull out the dividing wall if there is ice in the freezer.
Do not remove the panel sticker when operating the
refrigerator.
8.1
Energy saving tips
Choose a well ventilated location which is protected from direct sunlight.
Allow hot food to cool down first before you put it in the refrigerator.
Do not open the refrigerator more often than necessary. If the door is left
open for more than 5 minutes, the light starts to flash.
Do not leave the door open for longer than necessary.
Defrost your refrigerator as soon as a layer of ice forms.
Avoid unnecessarily low temperature settings.
Clean dust and dirt from the condenser at regular intervals.
EN
Using the refrigerator
23
Publicidad
