EN
Fig. 11
Fig. 12
• Open the rubber cap of the B602 system.
• Reassemble the gasket and secure it with the specific screw.
10
• Position the microphone in the housing on
the right of the helmet, inserting the boom
pole of the microphone in the groove found
in the chin guard coupling frame (Fig. 11).
Caution: make sure that the side of the
microphone support with the writing "n" is
facing inward.
N.B.: For positioning of the keypad in helmets
N87, N80-8 and N100-5, follow the instructions
provided in the dedicated box.
• Fix the cable inside the helmet and make
sure the left fixing clip snaps into its housing.
• Hook up the keypad to the helmet by
clicking in the relevant hooks.