N-Com R Serie Manual De Instrucciones página 54

EN
4. BASIC FUNCTIONS
Note: Before using the N-Com device for the first time, recharge the battery completely for at least 10
hours. To obtain best performances from the battery, it is recommended to completely recharge the
battery the first few times. Afterwards, you can recharge the battery for shorter periods. Whenever
possible, it is best to recharge the battery completely.
System ON
System OFF
4.1. Complete Mode and Simple Mode
The B602 system offers two user modes, Complete and Simple. You choose which mode you prefer
according to your requirements, thus making the most of your experience on the road.
Available functions depend on which user mode is selected. At the beginning of each section below,
you will find confirmation as to whether the function is available only in Complete Mode. If this is not
specified, the function on this system can be used in both user modes.
The system is preset with Complete Mode.
It is possible to change to Simple Mode as follows:
Via the N-Com system
- Whilst the system is switched off, press and hold the "n" and "" keys simultaneously for 5 seconds.
- You will hear the voice message "
- The system will shut down. When you next turn it on, Simple Mode will have been activated.
To reactivate Complete Mode, follow the above steps. You will hear the voice message "
interface disable
".
Via the N-Com EASYSET app
- Access the "Basic Settings" menu and enable the "Simple Mode" option.
Via your computer using the N-Com EASYSET program
- Access the "Settings" menu and select "Simple Mode".
4.2. Volume adjustment
You can easily adjust the volume by tapping the "" or the "" key. You will hear a beep when the
volume reaches the maximum or minimum level.
Some volume parameters can be adjusted through the N-Com EASYSET APP for smartphone or the
N-Com EASYSET computer program (chapter 4.5).
N.B.: The volume level set during the trip is not stored when the system is turned off. Each time the
N-Com system is switched on, the audio goes back to the set default volume level.
16
Press and hold the "n" key for about 2 seconds, until the LEDs turn on
and you hear the voice prompt.
Press and hold the "n" key for about 4 seconds, until the LEDs turn off
and you hear the voice prompt.
Simple user interface enable
".
Simple user