N-Com R Serie Manual De Instrucciones página 65

From intercom B
To enable the intercom connection, press the "Voice Call" or "Last number redial" command.
To disable the intercom connection, press the "Hang up" or "Reject phone call" command.
N.B.: Some systems are not able to handle the activation / deactivation of the intercom connection. In
this case, operate from the B602 system.
N.B.:
During use of the UNIVERSAL INTERCOM, the B602 system keeps the connection active to the
•
MAIN DEVICE only (and not to the SECOND MOBILE PHONE or to the SATELLITE NAVIGATOR).
The intercom system connected to N-Com B602 may not allow simultaneous connection to a
•
mobile phone.
Only one system paired in Universal Intercom mode can be stored.
•
14. REMOTE CONTROL
"Remote Control"
The
The B602 device can be controlled by using a remote control (sold separately), so that you do not
have to take your hands off the handlebars to use the keypad.
The N-Com system is compatible with the RC4 Remote Control by SENA.
The following table shows the correspondence of the keys:
N-COM SYSTEM
SENA RC4
Proceed as follows to pair the N-Com system to the RC4 Remote Control:
Make sure the RC4 is switched off.
•
Put the RC4 in pairing mode: press and hold the "+" key for about 8 seconds.
•
Make sure the B602 is switched off.
•
Put the B602 system in "Pairing" mode: press and hold the "n" key for 4 seconds, until the red LED
•
light appears.
Press the "" key until you hear the voice prompt "
•
Press the "n" key on the N-Com system keypad.
•
After a few seconds, the connection between the two devices is confirmed by the voice prompt
•
Remote control connected
"
N.B.: The affiliation is saved by both the helmet and the remote control and it is not lost when the two
systems are turned off. Hence this procedure must only be carried out once.
function is available only in Complete Mode.
▲ ▼
+ - CENTRAL KEY
".
n
MULTI-FUNCTION KEY
Remote control pairing
/
".
27