Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTION
2
Safety information
2.1
General safety notes
2.2
Correct use
en
3
Product description
4
Commissioning
4.1
Check the application conditions
18
O P E R A T I N G I N S T R U C T I O N | GRSE18
Connection, mounting and configuration of the product must only be car‐
ried out by qualified personnel.
This product does not constitute a safety component as defined in the
NO
Machinery Directive.
2006/42/EC
SAFETY
Do not install the product in places exposed to direct UV radiation (sun‐
light) or other weather conditions.
The product must be adequately protected against moisture and contami‐
nation.
The GRSE18 is an opto-electronic through-beam photoelectric sensor (referred to as
"sensor" in the following) for the optical, non-contact detection of objects, animals, and
persons. A sender (GRS) and a receiver (GRE) are required for operation. If the product
is used for any other purpose or modified in any way, any warranty claim against SICK
AG shall become void.
Observe the application conditions: Adjust the distance between the sender and the
receiver according to the corresponding diagram (x = sensing range, y = operating
reserve).
If several through-beam photoelectric sensors which are installed next to one another
are to be used, we recommend swapping the sender/receiver arrangement at every
second through-beam photoelectric sensor and ensuring that there is sufficient dis‐
tance between the through-beam photoelectric sensors. By doing this, mutual interfer‐
ence can be prevented.
8016954.1HT2/2022-11-11 | SICK
Subject to change without notice
Publicidad
