Publicidad
Idiomas disponibles
Idiomas disponibles
FAN ALIGNMENT AND HANGER BRACKET INSTALLATION (Continued)
1. To attach ceiling support cable (JJ), drill a
1/4 in. pilot hole, located independently from
the junction box (not included), into the ceiling
joist or structural member. Securely attach the
ceiling support cable (JJ) with the short lag
bolt (GG) and steel washer (EE). (Fig. 1)
NOTE: Ceiling support cable must be fastened in
the ceiling joists with 2 in. lag bolt.
WARNING
Failure to follow these hanger bracket
installation procedures may result in
damage to hanger bracket.
Hardware Used
Short Lag
GG
Bolt
Steel
EE
Washer
Ceiling
JJ
Support Cable
2. To begin mounting the hanger bracket (C), drill
a 1/4 in. pilot hole through the center of the
junction box, into the ceiling joist or structural
member, independent of the junction box.
Loosely attach the hanger bracket (C) to the
ceiling structure using the long lag bolt (HH)
and flat washer (EE). Do not fully tighten the
long lag bolt (HH) yet. Hanger bracket (C)
should be free to rotate. (Fig. 2)
NOTE: No lubrication to be used on screw. Pilot
hole for lag screw to be no larger than 1/4 in
diameter. Screw must have at least 1-1/2 in of
thread engagement into structure joist.
Hardware Used
Long Lag
HH
Bolt
Steel
EE
Washer
1
x 1
x 1
x 1
2
x 1
x 1
10
EE GG
JJ
1½ in.
Minimum
EE
HH
C
Publicidad
