Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: The touch sensor lock will not be
activated in CHRONOGRAPH mode when the
chronograph is in use.
NOTE: You can leave the chronograph running
while switching over to other operating modes.
The chronograph indicator
in NORMAL TIME / WORLD TIME mode when
the chronograph is in use.
NOTE: The chronograph can record up to
a maximum of 50 laps. If you try to record
more than 50 laps, the split number will not
be shown to indicate that no more lap can
be stored.
TO USE THE RECALL MODE:
1. Press S3 sensor to select RECALL mode.
2. After approximately 1 second, the total
elapsed time [TTL] or the message "NO
LAPS" (if there is no stored lap record) will
be displayed.
3. Press S1 sensor to cycle the stored lap
records in the order of total elapsed time
[TTL], fastest lap time [FST], slowest lap
time [SLW], average lap time [AVG] and
individual lap record [LAPXX].
4. When the individual lap record [LAPXX]
is displayed, press S2 sensor to cycle the
stored individual lap records.
NOTE: In RECALL mode, the watch will
automatically return to NORMAL TIME mode
if there is no sensor pressed for approximately
3 minutes.
TO SET THE TIMER:
1. Press S3 sensor to select TIMER mode.
2. Press and hold S2 sensor for approximately
3 seconds, the second digits will blink.
Press S1 sensor to increase or S2 sensor to
decrease the value.
3. Press S3 sensor, the minute digits will blink.
Press S1 sensor to increase or S2 sensor to
decrease the value.
4. Press S3 sensor, the hour digits will blink.
Press S1 sensor to increase or S2 sensor to
decrease the value.
5. Press S3 sensor, the action-at-end* setting
will blink. Press S1 or S2 sensor to cycle
forward or backward through STOP AT END
[STP AT End], REPEAT AT END [RPT AT End]
and UP AT END [UP AT End].
6. When finished making all the settings, press
and hold S3 sensor for approximately 2
seconds to confirm.
NOTE*: Illustration of the action-at-end
setting:
a) STOP AT END – the timer will stop when the
countdown reaches zero.
b) REPEAT AT END – the timer will reload and
repeat the countdown when the countdown
reaches zero.
c) UP AT END – the timer count up to a maxi-
mum of 23 hours, 59 minutes and 59.99
seconds when the countdown reaches zero.
TO USE THE TIMER:
1. Press S3 sensor to select TIMER mode.
2. The timer will be displayed in its current
state –reset [RST], running [RUN] or
stopped [STP].
3. Press S1 sensor to start counting.
4. To stop counting, press S1 sensor. Press S1
sensor again to resume from where it left
off.
5. To reload the timer, press S1 sensor to stop
counting and then press and hold S2 sensor
for approximately 3 seconds.
6. Upon completion of a countdown, the watch
will react according to the action-at-end
setting selected:
If STOP AT END is selected, the timer will
stop when the countdown reaches zero. A
20-second timer alert tune will be emitted.
If REPEAT AT END is selected, the timer will
reload and repeat the countdown when the
countdown reaches zero. If the timer is set
to be less than 10 seconds, a "beep" sound
will be emitted; if the timer is set to be 10
seconds or more yet less than 30 seconds,
a "beep-beep" sound will be emitted; if the
timer is set to be 30 seconds or more, a
20-second timer alert tune will be emitted.
If UP AT END is selected, the timer will
count up to a maximum of 23 hours, 59
minutes and 59.99 seconds when the
countdown reaches zero. A 20-second timer
alert tune will be emitted.
NOTE: The touch sensor lock will not be acti-
vated in TIMER mode when the timer is in use.
Freestyle_ Touch Compass-AG8920-R02.indd 3
NOTE: You can leave the timer running while
switching over to other operating modes. The
timer indicator
REPEAT AT END [RPT AT End] and
END [UP AT End] will be displayed in NORMAL
TIME / WORLD TIME mode when the timer
will be displayed
is in use.
TO SET THE ALARM TIME:
1. Press S3 sensor to select ALARM mode.
2. Press S2 sensor to toggle between ALARM 1
[AL1] and ALARM 2 [AL2] to set.
3. Press and hold S2 sensor for approximately
3 seconds, the minute digits will blink.
Press S1 sensor to increase or S2 sensor to
decrease the value.
4. Press S3 sensor, the hour digits will blink.
Press S1 sensor to increase or S2 sensor to
decrease the value.
5. Press S3 sensor, the time mode setting (to
determine which time mode will the se-
lected alarm be reacting to) will blink. Press
S1 or S2 sensor to toggle between NORMAL
TIME [HT] and WORLD TIME [WT]
6. When finished making all the settings, press
and hold S3 sensor for approximately 2
seconds to confirm.
NOTE: The alarm will automatically be acti-
vated after being set.
TO TURN ON/OFF THE ALARM:
1. Press S3 sensor to select ALARM mode.
2. Press S2 sensor toggle between ALARM 1
[AL1] and ALARM 2 [AL2].
WORLD TIME CITY CODE REFERENCE TABLE:
STOP AT END [STP AT End],
GMT
City
City
Differential
Code
1
-11
PPG
PAGO PAGO
2
-10
HNL
HONOLULU
3
-9
ANC
ANCHORAGE
4
VAN
VANCOUVER
-8
5
LA
LOS ANGELES
6
DEN
DENVER
-7
7
ME
MEXICO CITY
-6
8
CHI
CHICAGO
9
MIA
MIAMI
-5
10
NYC
NEW YORK
-4
11
SAN
SANTIAGO
RIO DE
12
-3
RIO
JANEIRO
13
+0
LONDON
LON
14
PARIS
PAR
15
MADRID
MAD
+1
16
ROME
ROM
17
BERLIN
BER
18
ISTANBUL
IST
+2
19
CAIRO
CAI
20
+3
MOSCOW
MOW
21
+4
DUBAI
DBI
22
+5
KARACHI
KHI
23
+5.5
DELHI
DEL
24
+6
DACCA
DAC
25
+7
BANGKOK
BKK
26
SIN
SINGAPORE
+8
27
HKG
HONG KONG
+9
TYO
28
TOKYO
GUM
GUAM
29
+10
SYD
SYDNEY
30
NOU
NOUMEA
31
+11
WLG
32
+12
WELLINGTON
3. Press S1 to toggle between ON and OFF
of the alarm. The message "ON" and the
alarm indicator
UP AT
the alarm is on. The message "OFF" will be
displayed when the alarm is off.
NOTE: When the alarm is on, the alarm indica-
tor
will be displayed in NORMAL TIME and
WORLD TIME mode as a reminder.
WHEN AN ALARM GOES OFF:
A 20-second alarm tune will be emitted at the
designated time when the alarm is activated.
If the alarm is done without any user interrup-
tion, the watch will automatically enter into a
snooze mode. The alarm will go off again after
60 seconds for 5 times.
When the alarm tune is being emitted, press
any sensor to stop the tune and terminate the
snooze function.
TO USE THE BACKLIGHT:
Press S4 sensor to turn on the backlight for
approximately 3 seconds.
Other major cities
in the same time zone
-------
PAPEETE
-------
LAS VEGAS, SEATTLE,
DAWSON CITY, SAN FRANCISCO
EL PASO, EDMONTON
HOUSTON, DALLAS / FORT WORTH,
NEW ORLEANS, WINNIPEG
MONTREAL, DETROIT, BOSTON,
PANAMA CITY, HAVANA, LIMA, BOGOTA
LA PAZ, SANTIAGO,PORT OF SPAIN
SAO PAULO, BUENOS AIRES,
BRASILIA, MONTEVIDEO
DUBLIN, LISBON, CASABLANCA,
DAKAR, ABIDJAN
MILAN, FRANKFURT,
AMSTERDAM, VIENNA,
ALGIERS, STOCKHOLM,
HAMBURG
ATHENS, HELSINKI, BEIRUT,
DANASCUS, CAPE TOWN, JERUSALEM
KUWAIT, RIYADH, ADEN,
ADDIS ABABA, NAIROBI
ABU DHABI, MUSCAT
-------
MUMBAI, KOLKATA
COLOMBO
JAKARTA, PHNOM PENH,
KANOI, VIENTIANE
KUALA LUMPUR, TAIPEI, PERTH,
BEIJING, MANILA, ULAANBAATAR
PYONGYANG, SEOUL
MELBOURNE, RABAUL
PORT VILA
CHRISTCHURCH, NADI,
NAURU ISLAND
To reduce carbon foot print, these
Freestyle instructions are printed with
soy inks on recycled paper.
ENGLISH
will be displayed when
3/27/12 4:25:28 PM
Publicidad
