Installation Site - Quick SBC 300 ADV PLUS FR Manual Del Usuario

EQUIPMENT NECESSARY FOR INSTALLATION
Depending upon model, use the batteries and cables on the output terminals as specified in the following
table:
MODEL
Battery voltage
Battery capacity
Minimum output cable size
The cables connected to the output terminals have a maximum length of 4 metres.
WARNING: the battery charger must be used only with re-chargeable lead/liquid electrolytic
batteries or lead/gel (sealed or non-sealed).

INSTALLATION SITE

Install the battery charger in a dry, ventilated place and as near to the batteries as possible. The battery
charger, although having high efficiency, develops a certain amount of heat during use, therefore, it is
imperative that the installation area has sufficient ventilation, enough to allow use of the equipment at
maximum power.
The battery charger can be installed in a horizontal or vertical position with cables coming out in the
downward position. The vertical position is recommended because the natural convection of heat helps
to cool the equipment. The perimeter of the battery charger (except the base) must be kept at a distance
from walls or objects by a minimum of 5 cm.
PART. B
CHARACTERISTICS AND INSTALLATION
SBC 300 ADV PLUS FR
140 ÷ 300 Ah
2
10 mm
SBC 500 ADV PLUS FR SBC 700 ADV PLUS FR SBC 650 ADV PLUS FR
12 V
180 ÷ 400 Ah
2
16 mm
PART. A
270 ÷ 600 Ah 140 ÷ 300 Ah
2
25 mm
GB
24 V
2
10 mm
FIG.1
17