Installation Site - Quick SBC 300 ADV PLUS FR Manual Del Usuario

EQUIPMENT NECESSARY FOR INSTALLATION
Depending upon model, use the batteries and cables on the output terminals as specifi ed in the following table:
MODEL
Battery voltage
Battery capacity
Minimum output cable size
Number of battery cells
The cables connected to the output terminals have a maximum length of 4 metres.
WARNING: the battery charger must be used only with re-chargeable lead/liquid electrolytic batteries or
lead/gel (sealed or non-sealed).

INSTALLATION SITE

Install the battery charger in a dry, ventilated place and as near to the batteries as possible. The battery charg-
er, although having high efficiency, develops a certain amount of heat during use, therefore, it is imperative that
the installation area has sufficient ventilation, enough to allow use of the equipment at maximum power.
The battery charger can be installed in a horizontal or vertical position with cables coming out in the down-
ward position.
The battery charger must be fi xed to the support surface with screws strong enough to support its weight.
The vertical position is recommended because the natural convection of heat helps to cool the equipment.
The perimeter of the battery charger (except the base) must be kept at a distance from walls or objects by a
minimum of 5 cm.
FIG.1
PART. B
SBC ADVANCED PLUS MEDIUM - REV005A
CHARACTERISTICS AND INSTALLATION
SBC 300 ADV PLUS FR
140 ÷ 300 Ah
10 mm 2
SCB 500 ADV PLUS FR SBC 700 ADV PLUS FR
12 V
180 ÷ 400 Ah
16 mm 2
6
PART. A
SBC 650 ADV PLUS FR
270 ÷ 600 Ah 140 ÷ 300 Ah
25 mm 2
GB
24 V
10 mm 2
12
15