Axis Communications Q1635-E Guia De Instalacion página 20

AXIS Q1635-E Network Camera
1. Prepare the wall for installation of the wall mount. Use the wall bracket as a template
and mark the holes before drilling the holes.
2. Route the network cable through the wall bracket. Leave approximately 30 cm (12 in) of
cable for connecting the camera.
3. If connecting an auxiliary device, for example an I/O, audio, to the camera, route
the cables through the wall bracket. Leave approximately 15 cm (6 in) of cable for
connecting the housing.
4. Fasten the wall bracket to the wall by tightening the screws.
Route the Network Cable Through the Cable Hole
NO NO NO TICE TICE TICE
Using any other than the provided cable gland may cause water to seep in and damage
the product. Cables must have a diameter of 4.0–5.5 mm.
Note
Check against the hardware overview image (see page 10) while following the steps below.
1
Cable gland
2
Gasket
3
Plug (discard)
4
Cap
1. Loosen the cable cover screws; detach the cable cover from the bottom cover.
2. Remove the cap, the plug and the gasket from the cable gland.
3. Route the network cable through the cap.
4. Slide the network cable through the slit on the gasket to attach the gasket to the network
cable. See Connectors on page 17 for information on network cable requirements.
5. Route the network cable through the cable gland.
6. Press the gasket into the cable gland and screw the cap on firmly.
20