Axis Communications Q1635-E Guia De Instalacion página 22

AXIS Q1635-E Network Camera
5. Install the top cover. Make sure to tighten diagonally opposite bottom cover screws a
few turns at a time until all are tight. This will help ensure that the bottom cover gasket
is compressed evenly. Do not tighten the screws completely the first time.
6. Install the cable cover and tighten the cable cover screws.
7. Loosen the sunshield adjustment screws and adjust the sunshield to the front position.
Connect the Cables
1.
Network connector (PoE IN)
2.
Cable holes
3.
LED indicator
1. Optionally insert an SD memory card (not included) into the SD card slot. A standard or
high capacity SD card is required to store images locally in the camera.
2. Optionally connect external input/output devices. See Connectors on page 17 for
information on the connector pins. See Route the Network Cable Through the Cable Hole
on page 20 for information on preparing the network cable. Route the cables through
the cable holes into the bottom cover and to the camera.
3. Connect the camera to the network using a shielded network cable and using the
network connector (PoE IN) on the bottom cover. The network cable and the I/O cable
between the bottom cover and the camera, are already connected at delivery.
4. Check that the indicator LEDs indicate the correct conditions. See LED Indicators on
page 12 for further details.
22