Axis Communications Q1635-E Guia De Instalacion página 23

Idiomas disponibles

Access the Product

AXIS IP Utility and AXIS Camera Management are recommended methods for finding Axis products

on the network and assigning them IP addresses in Windows®. Both applications are free and can

be downloaded from www.axis.com/techsup

The product can be used with most operating systems and browsers. The recommended browsers are

•

Internet Explorer

•

Safari

with OS X

•

Chrome

or Firefox

For more information about using the product, see the User Manual available at www.axis.com

Status LED Behavior and Buzzer Signal for Levelling Assistant

For information on the Function button used for levelling the camera, see Connectors and Buttons.

Press and hold the function button (2) for more than two seconds to level the camera.

•

When the camera is level, both LEDs are steady green, and the beep is continuous.

•

When the camera is not level, the LEDs flash a combination of red, green and orange, and

the beep occurs at slow intervals.

Both LEDs briefly flash green to indicate that the levelling is getting better.

Adjust Focus

To adjust the zoom and focus follow these instructions:

Note

• Set focus as precisely as possible with the focus ring or Focus Assistant before starting

automatic fine tuning. Using the focus ring normally gives the best result.

• The iris should always be opened to its maximum while focusing. This gives the smallest

depth of field and thus the best conditions for correct focusing.

1. Open the product's home page and go to Setup > Basic Setup > Focus.

2. Under the Basic tab, click Open iris. If the button is inactive the iris is already open.

3. If focus has been set before, click Reset to reset the back focus.

4. Loosen the zoom puller and the lock screw for the focus ring (see Hardware Overview on

page 10) on the lens by turning them counter-clockwise. Move the zoom puller and the

focus ring to set zoom and focus and check the quality of the image in the image window.

If the camera is mounted so that one cannot look at the image and move the pullers at

the same time, use the Focus Assistant instead.

AXIS Q1635-E Network Camera

with Windows

with other operating systems.