Publicidad
Idiomas disponibles
Idiomas disponibles
SM 2610023206 02-12:SM 2610023206 02-12.qxp 2/15/12 1:17 PM Page 8
Attaching the Blad e
To prevent personal injury,
WARNING
always disconnect plug from
power source before assembling parts, making
adjustments, or changing blades.
1. Loosen blade screw in the side of blade
holder with the 2.5 mm wrench provided and
insert blade to full depth with teeth facing in
direction of cut as shown in (Fig. 2).
TRIGGER "ON-OFF" SWITCH
TO TURN THE TOOL "ON" squeeze the
trigger switch. TO TURN THE TOOL "OFF",
release the trigger switch, which is spring
loaded and will return to the "OFF" position
automatically.
"LOCK-ON" BUTTON
The "Lock-ON" button, located in the handle of
your tool allows for continuous operation at
maximum SPM without holding the trigger
(Fig. 1).
DUST ExTRACTION
Your tool is equipped with a dust port for dust
extraction. To use this feature, attach
vacuum hose (optional accessory) to the dust
port, and connect the opposite end of the
hose to a shop vacuum cleaner (Fig. 4).
Assembly
For use with only U shank jigsaw blades.
When inserting the saw blade, the back of
the blade must rest in the groove of the guide
roller (Fig. 3).
2. Securely tighten blade screw on the side of
blade holder with the 2.5 mm wrench provided
(Fig. 2).
FIG. 2
BLADE
HOLDER
BLADE
SCREW
Operating Instructions
TO LOCK TRIGGER "ON": squeeze trigger,
depress button and release trigger.
TO UNLOCK THE TRIGGER: squeeze trigger
and release it without depressing the "Lock-
ON" button.
WARNING
the trigger can not be released.
-8-
ROLLER
If the "Lock-ON" button is
continuously being depressed,
DUST PORT
VACUUM HOSE
(Optional accessory)
FIG. 3
BLADE
GUIDE
FIG. 4
Publicidad
