Publicidad
Idiomas disponibles
Idiomas disponibles
2
M18™ Wireless Monitor
M18™ 500GB Control Hub – The Control Hub is powered by its M18™ Battery which is
hot-swappable. If the battery is removed from a running Control Hub, the below message
will appear warning that the Control Hub is operating on the internal backup battery for
a period of nine minutes. During these nine minutes a charged M18™ Battery must be
installed, or a USB cable must be attached between the Wireless Monitor and Control
Hub. The USB cable will now power the Wireless Monitor temporally.
Typical battery life: M18™ Wireless Monitor: Nine hours on a fully charged battery
M18™ 500GB Control Hub: Nine hours on a fully charged battery
2021/09/26 01:47:57 AM
2021_09_26_A
2.2.12 Setting the LCD Screen Settings
This setting adjusts the M18™ Wireless Monitor LCD screen settings.
1. Turn the navigation dial to Settings
2. Turn the navigation dial to Screen Settings, press to enter the sub-menu.
3. Use the navigation dial to navigate through the menu choices, press the navigation
dial to select one.
4. Turn the navigation dial left and right to adjust the setting, press the navigation dial to
accept it.
5. Scroll to the bottom of the sub-menu and press the navigation dial on OK to accept the
changes.
Camera Light
Replace Control Hub battery or connect
cable to Wireless Monitor immediately
Time remaining : 08:51
, press the navigation dial.
Hue
Brightness
Contrast
Saturation
Backlight
Cancel
25
9.3FT
50
50
50
50
8
OK
Publicidad
