Milwaukee 2970-20 Manual Del Operador página 55

3 M18™ 500GB Control Hub
Remove the four combination head screws to access the camera test port
1. With the Control Hub powered off, remove it from the reel.
2. On the rear of the Control Hub, remove the four combination head screws from
the camera test port cover.
3. Screw the camera head onto the male threads of the test port. Hand tighten only.
4. Power on the Control Hub.
5. Power on the M18™ Wireless Monitor or tablet running the Milwaukee
Inspection App, and connect to the Control Hub checking for picture and control of the
cameras LED's.
3.4 Formatting the M18™ Control Hub Internal and
Thumb Drives
This setting allows the formatting of the M18™ 500GB Control Hub's Internal 500GB
Drive or a USB thumb drive. The system requires that USB thumb drives be formatted in
the FAT32 file system.
Any new thumb drives should already be formatted in FAT32 but if the Control Hub does
not recognize the USB Thumb Drive follow the below instructions making sure to select
Control Hub Thumb Drive. Alternatively, a USB thumb drive can be formatted in a
desktop PC or laptop. See the end of this section on instructions on how to do this.
Formatting the M18™ Control Hub or Thumb Drives
1. Turn the navigation dial to Settings
2. Turn the navigation dial to Format Disk, press the navigation dial to enter the sub-
menu.
Select the Control Hub Internal Drive (Hub SSD) or the Control Hub Thumb Drive (Hub
USB) and press the navigation dial.
, press the navigation dial.
51
®
Pipeline