Milwaukee 2970-20 Manual Del Operador página 37

2 M18™ Wireless Monitor
6. Press the Back button to exit and return to the main viewing area.
2.3.7 Screen Rotate
Screen Rotate – will invert the upright picture 90° with each push of the navigation dial.
This is helpful while using the reel in the horizontal position, and the monitor may not be
in an upright position.
1. Turn the navigation dial to Rotate
Rotate option.
2. With each press of the navigation dial, the screen will Rotate 90° to the right.
CAMERA LIGHT
2021/09/26 01:47:57 AM
2021_09_26_A
0 Degrees (default)
2021_09_26_A
180-degree position
Note: The screen will remain in a Rotate position until it is adjusted back to the default in
this setting.
2.3.8 Line Trace
Line Trace – activates the internal transmitter to inject a locate signal onto the push
cable. The length of deployed push cable can now be located and traced above ground
with a locator set to the matching Line Trace frequency. The M18™ 500GB Control Hub
must be properly grounded when using the Line Trace feature. See section 3.3.3 in this
manual covering the Grounding Post for additional information.
1. Turn the navigation dial to Line Trace
2. Turn the navigation dial to select a Line Trace frequency of 33kHz or 83kHz and
press the navigation dial.
Rotate
9.3FT
Rotate
, press the navigation dial to start the screen
2021_09_26_A
90 Degree position
2021_09_26_A
270-degree position
, press the navigation dial.
33
Rotate
Rotate