Publicidad
Idiomas disponibles
Idiomas disponibles
5 ASSEMBLY
10
–
Repeat the steps for chambers
six chambers are fitted with the correct tumblers.
–
Insert the key.
All tumblers close flush with the locking cylinder.
500518-01
–
Mount and tighten short locking cylinder adapter
screw (both included).
The holding lug of the locking cylinder adapter (see
arrow) is located on the opposite side of the engaging
plate
501998-01
–
Grease and mount the O-ring
Long-life grease (
–
Position and insert the locking cylinder as shown in the
figure.
The holding lug of the locking cylinder adapter is
facing downward.
Engaging plate
501999-01
–
Move the key into top position
The topcase is closed and locked.
–
Move the key 90° to the right
The topcase can be opened and closed.
–
Move the key 45° to the right
The handle pops up automatically.
The securing lever swings out automatically.
The topcase can be opened and closed.
500531-01
The topcase is released and can be mounted or remo-
ved.
Opening the topcase
–
Move the key 90° to the right
–
Slide the push button to the rear fully, press down and at
the same time, open the cover.
502000-01
B
D
,
bq
.
6
(included).
p. 17)
bq
engages.
G
.
H
.
I
.
H
.
F
, and
until all
5
with
Publicidad
