Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
Depth gauges that are too low increase
the kickback tendency of the chain saw.
Sharpening tools (special accessories)
Chain pitch
Round file ^
Inches
(mm)
mm (Inches) Part number
1/4 P
(6.35)
3.2
(1/8)
1/4
(6.35)
4.0
(5/32)
3/8 P
(9.32)
4.0
(5/32)
0.325
(8.25)
4.8
(3/16)
3/8
(9.32)
5.2
(13/64)
0.404
(10.26) 5.5
(7/32)
1)
consisting of file holder with round file, taper square file and file gauge
MS 150 C
Lay the file gauge on the saw chain
N
– the highest point of the depth
gauge must be flush with the file
gauge
Round file
File holder
Part number
5605 771 3206
5605 750 4300
5605 772 4006
5605 750 4327
5605 772 4006
5605 750 4327
5605 772 4806
5605 750 4328
5605 772 5206
5605 750 4329
5605 772 5506
5605 750 4330
After sharpening, clean the saw
N
chain thoroughly, removing any
filings or grinding dust – lubricate
the saw chain thoroughly
In the event of extended periods of
N
disuse, store saw chains in cleaned
and oiled condition
File gauge
Taper square file Sharpening set
Part number
Part number
0000 893 4005
0814 252 3356
1110 893 4000
0814 252 3356
1110 893 4000
0814 252 3356
1110 893 4000
0814 252 3356
1110 893 4000
0814 252 3356
1106 893 4000
0814 252 3356
English
1)
Part number
5605 007 1000
5605 007 1027
5605 007 1027
5605 007 1028
5605 007 1029
5605 007 1030
47
Publicidad
