SCREW
MOUNTING THE TABLE SAW BASE TO THE
QUICKSTAND
®
See Figure 8.
Place the table saw base on the leg stand. Position the
locking knob over the holes in the top of the leg stand.
Insert the screw on the locking knob into the hole and
turn the locking knob clockwise to secure the table saw
base to the leg stand.
Repeat with the other three locking knobs.
TO INSTALL THE HANDLE
See Figure 9.
Hold the nylon nut securely and turn the screw counter-
clockwise to remove the nut completely.
NOTE: Do not remove the screw from the handle.
Place the nylon nut into the recessed hole on the back of
the height/bevel adjusting handwheel and hold in place.
Slide the handle and screw into the hole on the height/
bevel adjusting handwheel.
Using a flathead screwdriver, turn the screw clockwise
and tighten in place.
ASSEMBLY
LOCK NUT
ARROWS
LEG BRACE
Fig. 6
15 - English
HOLE
NUT
WASHER
HEIGHT/BEVEL
ADJUSTING HANDWHEEL
Fig. 7
LOCKING
KNOB
Fig. 8
HANDLE
SCREW
Fig. 9