Publicidad
Idiomas disponibles
Idiomas disponibles
4.1 - CLEANING
4.1.1 - Cleaning the indoor unit and remote controller
Use a dry cloth to clean the indoor unit and the remote control.
a cloth dampened in cold water can be used to clean the indoor unit if it is very dirty.
the front panel can be removed and cleaned with water. Dry using a dry cloth.
Do not use a chemically-treated or anti-static cloth to clean the unit.
Do not use gasoline, solvent, polish or similar solvents.
These products could cause the breakage or deformation of the plastic surface.
4.1.2 - Cleaning the air filter (fig. "41", "43", "44" e "45")
A clogged air filter reduces the cooling efficiency of this unit. Please clean the filter once every 2 weeks.
a. Lift the indoor unit panel up to an angle until it stops with a clicking sound (fig. "41").
b. Take hold of the handle of the air filter and lift it up slightly to take it out from the filter holder (fig. "43a"),
then pull it downwards (figura "43b").
c. Remove the air filter.
d. Clean the air filter using a suction device or wash it with water and then dry it in a cool place.
e. Remove the electrostatic filter (if provided to accompany) and the active carbon filter (if provided to ac-
company) from the air filter as shown in figure "44".
Do not touch this Electrostatic Filter within 10 minutes after opening the inlet grille,
it may cause an electric shock.
f. Clean the electrostatic filter with mild detergent or water and dry in the sunlight for two hours.
g. Insert the electrostatic filter again (if supplied) + the active charcoal filter (if supplied).
h. Insert the upper part of the air filter into the unit, paying attention that the left and right edges are correctly
aligned and then re-position the filter in the relevant seat (figure "45").
i. Close the panel well, taking it back to its original position (figure "46").
4.2 - MAINTENANCE
if you plan to idle the unit for a long time, perform the following:
a. activate the fan for approx. half a day to dry the inside of the unit.
b. Stop the air conditioner and disconnect the power supply.
c. remove the batteries from the remote control.
The outdoor unit requires maintenance interventions and periodic cleaning.
DO NOT PERFORM THEM ALONE.
Contact the dealer or after-sales assistance service.
Checks before resuming use of the air conditioner:
a. Check that the wires are not broken or disconnected.
b. Check that the air filter is clean and installed correctly.
Clean the filters after a long period of inactivity of the air conditioner.
c. Check that the air outlet or inlet are not obstructed (especially after a long period of inactivity of the air
conditioner).
EN - 34
Publicidad
