EN
1
DESCRIPTION
1.1
PURPOSE
The product fitted with a cutting attachment mounted on a
pole to enable the operator to cut the branches of standing
trees but not intends for cutting woods as normal chainsaw.
This appliance is not intended for use by persons (including
children) with reduced understanding, or lack of experience
and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play
with the appliance.
1.2
OVERVIEW
Figure 1-20
Chain
1
Extension pole
2
Pole saw handle
3
Scabbard
4
Wrench
5
Pole saw head
6
Lock nut
7
Press button
8
Lock sleeve
9
10 Press button hole
11 Arrow
12 Shoulder strap
13 Carrying ring
14 Carabiner
2
SAFETY
Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3
INSTALLATION
3.1
UNPACK THE MACHINE
Make sure that you correctly assemble the machine before
use.
15 Oil tank cap
16 Lock-out button
17 Trigger
18 Chain cover knob
19 Chain cover
20 Bar
21 Sprocket
22 Chain tension pin
hole
23 Bar stud
24 Bar stud slot
25 Chain cutter direction
26 Chain adjustment
screw
WARNING
WARNING
English
•
If the parts are damaged, do not use the machine.
•
If you do not have all the parts, do not operate the
machine.
•
If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.2
ADD THE BAR AND CHAIN
LUBRICANT
Examine the amount of oil in the machine. If the oil level is
low, add the bar and chain lubricant as follows.
Use bar and chain lubricant that is only for chains and chain
oilers.
The machine comes from the factory without bar and chain
lubricant.
1. Loosen and remove the cap from the oil tank.
2. Put the oil into the oil tank.
3. Monitor the oil indicator to make sure that no dirt in the
oil tank while you add the oil.
4. Put the oil cap on.
5. Tighten the oil cap.
6. The whole oil tank will last for 15 - 40 minutes.
Do not use dirty, used or contaminated oil. Damage can
occur to the bar or chain.
3.3
ASSEMBLE THE GUIDE BAR AND
THE CHAIN
Figure 9-14
1. Loose the chain cover by turning the chain cover knob
counterclockwise.
2. Remove the chain cover.
3. Put the chain drive links into the bar groove.
4. Put the chain cutters in the direction of the chain
operation.
5. Put the chain in position and make sure that the loop is
behind the guide bar.
4
WARNING
IMPORTANT
NOTE
IMPORTANT