Publicidad
Idiomas disponibles
Idiomas disponibles
4. Remove burr from the edges and level the cutters with a
flat file.
Replace the bar if:
•
the groove is not fit with the height of the drive links
(which must never touch the bottom).
•
the inside of the guide bar is worn and make the chain
lean to one side.
6
TRANSPORTATION AND
STORAGE
Before you move the machine, always
•
Remove the battery pack from the machine.
•
Keep hands clear of the lock-out button.
•
Put the scabbard on the guide bar and the chain.
Before you put the machine into storage, always
•
Remove all residual oil from the machine.
•
Remove the battery pack from the machine.
•
Clean all unwanted material from the machine.
•
Make sure that the storage area is
•
Not available to children.
•
Away from agents which can cause corrosion, such as
garden chemicals and de-icing salts.
7
TROUBLESHOOTING
Problem
Possible cause
The machine does
The poles are not
not start.
assembled cor-
rectly.
The lock-out but-
ton and trigger are
not depressed at
the same time.
English
Problem
The bar and chain
gets hot and
smokes.
The bar and chain
gets too hot and
can not cut.
The motor runs,
Solution
but the chain does
not cut correctly,
Assemble the
or the motor stops
poles according to
after around 3
the instructions.
seconds.
1. Push and hold
the lock-out
button
2. While you
8
hold the lock-
out button,
Voltage
pull the trig-
ger.
No load speed
3. Release the
Guide bar length
lock-out but-
ton to start the
Chain stop
machine.
Chain oil capacity
Weight (without battery
pack)
Measured sound pressure
level
Guaranteed sound power
level
Vibration
Chain
7
Possible cause
Oil tank is empty. Fill the oil tank.
The discharge
port is blocked.
Inlet opening of
inner oil tank is
blocked.
The sprocket is
stuck and clogged
with debris.
The chain tension
is too tight or too
loose.
The chain is dull
The chain is put
on backwards.
When you use the
machine under
load, it stops.
The chain is not
lubricated.
TECHNICAL DATA
60V DC
10.5 m/s
254 mm
< 3 s
80 ml
4.5 kg
L
= 79 dB(A), K
pA
dB(A)
L
= 100 dB(A)
wA.d
< 2.5 m/s
25AP058X
EN
Solution
1. Remove the
battery pack.
2. Remove dirt
from the dis-
charge port.
1. Clean the oil
tank.
2. Fill with clean
bar and chain
lubricant.
1. Clean the
sprocket.
2. Fill with clean
bar and chain
lubricant.
Refer to Adjust
the Chain Tension
in the manual.
Sharpen or re-
place the chain.
Take out the chain
and turn it in the
right direction.
1. Release the
trigger.
2. Start the ma-
chine again.
Lubricate the
chain to decrease
the friction.
= 3
pA
2
2
, K = 1.5 m/s
Publicidad
