Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
warNiNg: Stop the mower
and remove the safety key
before removing the grass bag.
NoTE: To ensure long and reliable service,
perform the following maintenance
procedures regularly. Check for obvious
defects such as a loose, dislodged or a
damaged blade, loose fittings, and worn
or damaged components. Check that the
covers and guards are all undamaged and
are correctly attached to mower. Carry
out any necessary maintenance or repairs
before operating mower. If the mower
should happen to fail despite regular
maintenance, please call our customer
helpline for advice, 1-866-354-9679.
bladE SharPENiNg
KEEP THE BLADE SHARP FOR BEST MOWER
PERFORMANCE. A DULL BLADE DOES NOT
CUT GRASS CLEANLY OR MULCH PROPERLY.
WEAR PROPER EYE PROTECTION
WHILE REMOVING, SHARPENING,
AND INSTALLING BLADE. ENSURE
THAT SAFETY KEY IS REMOVED.
Sharpening the blade twice during a mowing
season is usually sufficient under normal
circumstances. Sand causes the blade to dull
quickly. If your lawn has sandy soil, more
frequent sharpening may be required.
REPLACE BENT OR DAMAGED
BLADE IMMEDIATELY.
whEN SharPENiNg ThE bladE:
1. Make sure blade remains balanced.
2. Sharpen the blade at the
original cutting angle.
3. Sharpen cutting edges on both ends of the
blade to keep it balanced, removing equal
amounts of material from both ends.
To SharPEN bladE iN a viSE (See N)
1. Be sure the switch lever is released, the
blade has stopped and the safety key
removed before removing the blade.
2. Remove blade from mower.
See instructions for removing
and attaching blade.
3. Secure blade N-1 in a vise N-2.
3-in-1 cordless lawn mower
4. Wear safety glasses and
heavy work gloves..
5. Carefully file the cutting edges
of the blade with a fine tooth file
N-3 or sharpening stone.
6. Check balance of blade. See
instructions for blade balancing.
7 . Replace blade on mower and tighten
securely. Refer to instructions below.
bladE balaNCiNg (See o)
Check balance of blade by placing
center hole in blade O-1 over a nail
or screwdriver shank O-2, clamped
horizontally in a vise O-3. If either
end of the blade rotates downward, file
that end. Blade is properly balanced when
neither end drops and the blade stays level.
bladE maiNTENaNCE (See P & Q)
Renew your metal blade after 50 hours
mowing or 2 years, which ever is the
sooner-regardless of condition.
Follow these procedures to remove and
replace the blade. You will need garden
gloves (not provided) and a spanner wrench
(not provided) to remove the blade. Hold the
blade (Q-2) and unscrew the blade nut (Q-5)
counterclockwise using a spanner wrench.
Remove blade nut (Q-5), square washer (Q-4),
insulator washer (Q-3), and blade (Q-2).
To re-assemble, first position the blade
with the cutting edges towards the
ground. Assemble the components.
Ensure that the edges of the insulator
washer hook over the edge of the blade.
Align the flats on the square washer
(Q-4) with the flats on the shaft.
Then securely tighten the blade nut.
NoTE: If the blade and insulator
washer (Q-3) are cracked or damaged,
replace with new ones.
STORAGE (See R)
Stop the mower and always remove
the safety key. Clean the exterior of
the machine thoroughly using a soft
brush and cloth. Do not use water,
17
17
EN
Publicidad
