Aventics RMV04-8DI M8 Instrucciones De Servicio página 73

1
2
Fig. 17: Mounting input/output module(s), example
1 Hexagonal socket-head screws
2 End plate left
3 Seal
4 Output module
AVENTICS | EtherNet/IP™ | R412012728–BDL–001–AC
3. Attach the (additional) input (5) or output module (4) to the tie rods (6).
– Make sure the seals (3) have been correctly inserted and that the contacts
have been properly connected.
4. Retighten the left end plate (2) after the last input module (5) or output module (4)
(2 DIN 912 – M4 hexagonal socket-head screws (1), wrench size 3).
Tightening torque: 2.5 to 3 Nm.
5. Establish the pneumatic connections (see "Connecting the bus coupler logic and
load supply" on page 53).
Open inputs/outputs
Danger of electric shocks caused by contact, short circuits, or damage to
the system.
Always close unused inputs or outputs with protective caps (see "Spare parts
and accessories" on page 75) to comply with the IP65 protection class.
6. Adjust the configuration (see "Configuring the bus coupler" on page 62).
6
6
5
3
4
3
5
6
7
Disassembly and Exchange
CAUTION
7
3
Input module
Tie rod
Bus coupler
73