Alliance Laundry Systems FLW700C Instalación página 10

Installation
Step 3: Connect Drain Hose to Drain
Receptacle
Remove the drain hose from its shipping position on
the rear of the washer by unhooking the hose from the
retainer clamp.
Find the instructions, on the following pages, that are
appropriate for your type of drain receptacle
(standpipe, sink, wall, or laundry tub). Follow these
instructions to properly install the drain hose.
IMPORTANT: Drain receptacle must be capable of
handling a minimum of 1-1/4 inch (3.2 cm) outside
diameter drain hose.
1
1 Retainer Clamp
Figure 5
Standpipe Installation
Place the drain hose into the standpipe.
Remove the beaded tie-down strap from accessories
bag and place around standpipe and drain hose and
tighten strap to hold hose to standpipe. This will
prevent the drain hose from dislodging from drain
receptacle during use.
8
FLW703N
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
1
2
3
1 24" to 36" (91.44 cm recommended height)
2 Standpipe 2" (5.08 cm) or 1-1/2" (4 cm)
3 Beaded Tie-Down Strap
Figure 6
Sink Installation
For this type of installation, use the beaded tie-down
strap (supplied in accessories bag) or use a large wire
tie (available from your local hardware store), and
secure the drain hose to the cabinet top hinge (refer to
Figure 7). This will prevent the drain hose from
dislodging during use.
1
2
1 Drain Hose
2 Tie-Down Strap (Wire tie or tape if
necessary)
Figure 7
FLW704N
FLW704N
FLW705N
FLW705N
800971