Alliance Laundry Systems FLW700C Instalación página 9

Installing the Unit
Step 1: Position Washer Near Installation
Area
IMPORTANT: Install dryer before washer. This
allows room for attaching exhaust duct.
Move washer as close to the desired area of
installation as possible.
Figure 2
Step 2: Connect Water Inlet Hoses
NOTE: Refer to section on Water Supply
Requirements before connecting water inlet hoses.
Remove the four plain rubber washers from
accessories bag, and install them according to
Figure 3.
Turn on the water supply faucets and flush the lines for
approximately two minutes to remove any foreign
materials that could clog the screens in the water
mixing valve.
800971
FLW702N
FLW702N
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
NOTE: When installing in newly constructed or
renovated building, it is very important to flush the
lines since build-up may have occurred during
construction.
IMPORTANT: Thread hose couplings onto valve
connections finger-tight, then approximately
1/4 turn with pliers. DO NOT cross thread or
overtighten couplings.
Turn water on and check for leaks. If leaks are found,
retighten the hose couplings. Continue tightening and
rechecking until no leaks are found.
1 Rubber Washer (Plain)
2 Inlet Hose
Figure 3
1
4
1 Water Supply Faucets
2 Cold Water Connection
3 Hot Water Connection
4 Water Inlet Hoses
Figure 4
Installation
1
2
H091I
H091I
2
3
WATER
MIXING
VALVE
FLW723N
FLW723N
7