Oase BioTec ScreenMatic2 40000 Instrucciones De Uso página 55

Fitting the outlet
BioTec ScreenMatic² 145000: The outlet is not fitted on delivery.
Prerequisite:
 The container is open. (→ Remove the container cover)
How to proceed:
1. Push the O-ring onto the outlet.
2. Position the outlet in the container wall from the outside.
– Ensure that the marking points up and is aligned with the holes in the container wall.
3. Use three oval head screws to screw the outlet to the container wall from the inside.
– Tighten the screws diagonally to ensure that the seal is uniformly applied.
– If you are using a cordless screwdriver: Do not set the screwdriver to "drill" to prevent dam-
age to the self-tapped thread. Then re-tighten the screws with a Torx screwdriver.
Installing the dirt outlet
BioTec ScreenMatic² 145000: The outlet is not fitted on delivery.
EN
BTC0064
Proficlear0347
55