SCHUBERTH E2 Manual página 26

C. THE HELMET
Fitting
1. Remove the visor from the helmet.
2. Use the notch to help position one side of the
anti-fog lens on one of the eccentric holding
pins. Make sure that the silicone seal is facing
the visor.
3. Carefully bend the visor just enough that
the notch is guided onto the other eccentric
holding pin on the opposite side of the anti-fog
lens. To do this, you will need to bend the end
of the anti-fog lens into a slight S-shape.
4. Checking the correct application of the
anti-fog lens, by trying to slide a piece of
paper between the visor and the anti-
fog lens. In case it gets between the
two, please adjusting the pins in order to
increase the strain of the anti-fog lens.,
5. In case of needs, it is possible to regulate the
pressure on the seal by adjusting the eccentric
locking-pins. To do so, remove the anti-fog lens,
then use a flat object with no sharp-edges to
push the locking pins out of the face shield
carefully from the inside; then rotate them by
180° and reinsert them. Fit the anti-fog lens
and check the seal.
26