Parkside PKSA 40-Li B2 Traduccion Del Manual De Instrucciones Originale página 44

GB IE
chine.
Observe the safety informa-
tion and notes on charging
and proper use as shown in
the instruction manual for
your battery and charger from
the Parkside X 20 V Team
series. A detailed description
of the charging process and
further information can be
found in the separate operat-
ing instructions.
Charging
Do not expose the battery to
extreme conditions such as
heat and shocks. There is a risk of
injury caused by leaking electrolyte
solution! In case of contact with
eyes or skin, rinse the affected sites
with water or a neutralizer and
seek medical attention.
The battery must only be char-
ged up in dry areas. The exter-
nal surface of the battery must be
clean and dry before being connec-
ted to the charger. There is a risk of
personal injuries from an electric
shock.
To recharge batteries of the PARKSIDE
X 20 V Team­series,­only­use­a­
charger belonging to the PARKSIDE
X 20 V Team­series.­­
•­ Charge­the­battery­before­using­it­for­
the­first­time.
•­ Always­comply­with­the­latest­safety­
information,­as­well­as­the­regulations­
and information relating to environmental
protection.
44
Charging the battery
If­warm,­allow­the­battery­to­cool­be-
fore charging. Charge the battery
(16)­when­only­the­red­LED­on­the­charge­
level indicator (
1.­ If­necessary,­remove­the­batteries­(16)­
from the tool.
2.­ Slide­the­batteries­(16)­into­the­char-
ging slot of the PARKSIDE­X 20 V Team
charger.
3. Plug the charger into a socket.
4.­ Once­charging­is­complete,­disconnect­
the charger from the mains supply.
5.­ Remove­the­batteries­(16)­from­the­
charger.
Overview of the LED indicators on
the charger:
Green LED illuminated while battery not
inserted: Charger is ready.
Green LED lights up: Battery is charged.
Red LED lights up: Battery charging.
Red LED flashes: Overheated
Red and green LED flash:
Battery defective
Assembly
Always wear protective
gloves when working with
the chainsaw and employ
only original parts. Pull out
the power plug before doing
any work on the chainsaw
itself – injury hazard!
Before putting the electric chain saw into
operation,­you­must:
-­ adjust­the­saw­chain­tension,
-­ pour­in­chain­oil,
24)­is­illuminated.