Parkside PKSA 40-Li B2 Traduccion Del Manual De Instrucciones Originale página 51

Felling trees
A lot of experience is neces-
sary in felling trees. Cut down
trees only when you can safely
handle the electric chainsaw.
In no case should you use the
electric chainsaw if you feel
unsure about anything.
•­ Ensure­that­no­people­or­animals­are­in­
the­field­of­action.­The­safety­distance­
between the tree to be felled and the
nearest-located workplace must be 2 ½
tree lengths.
•­ Note­the­felling­direction:
The user must be able to move safely
near­the­felled­tree,­to­saw­off­the­tree­
easily and remove branches.It is to be
avoided that the felled tree snags itself
on another tree. Note the natural felling
direction,­which­is­dependent­on­the­
slope and curvature characteristic of
the­tree,­wind­direction­and­the­number­
of branches.
•­ In­the­case­of­sloping­ground,­stand­
above the tree to be felled.
•­ Small­trees,­with­a­diameter­of­15-18­
cm,­can­usually­be­sawn­off­with­one­cut.
•­ In­case­of­trees­with­a­larger­diameter,­
a notched cut and a back cut must
be implemented (See „
notch" and „
•­­ If­cutting­and­felling­is­being­carried­
out by two or more persons simultane-
ously,­the­distance­between­the­felling­
and cutting persons must be at least
twice the height of the tree to be fellled.
When­felling­trees,­ensure­that­no­other­
persons are subject to hazards and that
no material damage is caused. If a tree
should come into contact with a power
line,­the­supply­company­must­be­in-
formed immediately.
3. Cutting
4. Felling­back­cut").
•­­ Dirt,­stones,­loose­bark,­nails,­clips­and­
wires must be removed from the tree.
Do not fell any trees when
a strong or changing wind
is blowing, if the danger of
property damage exists or if
the tree could fall on electric
wires.
Immediately after termination of
the­sawing­procedure,­remove­the­
ear protection so that you can hear
hooter and alarm signals.
1. Removal of branches:
Remove hanging branches by positioning
the cut from above the branch. With re-
moval­of­branches,­never­work­higher­than­
shoulder level.
2. Escape area:
Remove the undergrowth around the tree to
ensure an easy escape. The escape area
(1)­should­be­around­45°­either­side­be-
hind­the­planned­felling­direction­(2).
3. Cutting notch (A):
Make a felling notch in the direction in
which you wish the tree to fall. Start with
the­bottom,­horizontal­cut.­The­cut­depth­
should be around 1/3 of the trunk diam-
eter. This will prevent the saw chain or the
guard rails from jamming when placing the
second chamfer. Now make a slanted saw
cut from above at an angle of roughly 45°
to meet exactly with the bottom saw cut.
never step in front of a tree
which is notched.
GB IE
51