Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
• Connect the equipment to the water tap.
Observe the regulations for the use of a
system separator.
• Turn on the water tap entirely.
Never operate the pressure washer
with a closed water tap. Dry run-
ning will damage the washer!
Be prepared for the recoil
force of the emitted water jet!
Ensure that you are stand-
ing firmly and that you are
holding the gun (13) securely,
otherwise you could injure
yourself or other people.
• Switch on the pressure washer with the
ON/OFF switch (3).
• Pull the lever (
turn on the washer.
Releasing the lever will switch off
the washer, but the pressure within
the system is retained.
•
You can lock the switch lever
(20) of the spray gun (13) with
the locking button (21).
Lock the switch-on lever to prevent
the pressure washer from being in-
advertently/accidentally started.
In case of leaks in the water
system, immediately switch
off the equipment at the on/
off switch (3) and disconnect
the mains cable (7) of the
equipment from the mains.
There is a risk of electric
shock. Start restoring the wa-
20) of the gun (13) to
ter connections (see "Initial
Operation – Setting up").
If there is still air in the equipment,
please proceed as follows:
Bleed the supply hose:
1. Remove the quick connector of the
supply hose from the water connection
coupling (5) and the water connection
with filter insert (4).
2. Turn on the tap until the water comes
out without bubbles.
3. Turn off the tap.
4. Connect the quick connector of the
supply hose to the water connection
coupling (5) and the water connection
with filter insert (4) on the device.
5. Turn on the tap fully.
Bleed the equipment:
6. Switch on the equipment at the on/off
switch (3) until the pressure has built up.
7. Switch off the equipment at the on/off
switch (3).
8. Depress the start lever (
spray gun (13) until the pressure is re-
leased.
9. Please repeat steps 6. to 8. several
times until there is no further air in the
equipment.
Interrupting operation
•
Release the lever (20) of the gun (13).
•
During prolonged work intervals turn off
the washer by its ON / OFF switch (3).
Ending operation
1. Release the switch lever (20) of the
spray gun (13).
2. Turn the pressure washer off using the
on/off switch (3).
GB
MT
20) on the
23
Publicidad
