Publicidad
Idiomas disponibles
Idiomas disponibles
1
English
Set the High Temperature Limit
Stop (optional)
Lift the handle (1).
Use a 4 mm �llen wrench to push the screw cover
into the handle (2). Retrieve the screw cover when
the handle is removed.
Use the 4mm �llen wrench to loosen the handle
screw 4 complete revolutions (3).
Remove the handle (4).
Remove the nut cover.
Turn the stem counter-clockwise.
Remove the handle screw from the cartridge stem
(1).
Remove the high temperature limit stop (2).
Replace the high temperature limit stop so that the
pin on the cartridge is in the desired slot on the
limit stop.
Note: the temperatures given in the diagram
assume a water heater temperature of 140° F, a
cold water temperature of 50°F and a water pres-
sure of 45 PSI.
Replace the nut cover (1).
Replace the handle screw. Use
the �llen wrench to turn the
screw 4 revolutions (2).
Replace the handle (1).
Tighten the handle screw (2).
Install the screw cover (3).
Publicidad
