Publicidad
Idiomas disponibles
Idiomas disponibles
Flush the Water System
Air in the water dispensing system can cause the water dispenser
to drip. After connecting the refrigerator to a water source or
replacing the water filter, flush the water system. Flushing the
water dispensing system forces air from the water line and filter,
and prepares the water filter for use.
NOTE: As air is cleared from the system, water may spurt out of
the dispenser.
1. Using a sturdy container, depress and hold the water
dispenser pad for 5 seconds, then release it for 5 seconds.
2. Repeat Step 1 until water begins to flow.
3. Once water begins to flow, continue depressing and releasing
the dispenser pad (5 seconds on, 5 seconds off) until a total
of 3 gal. (12 L) has been dispensed.
Additional flushing may be required in some households.
The Water Dispenser
IMPORTANT:
Dispense at least 1 qt (1 L) of water every week to maintain a
fresh supply.
If the flow of water from the dispenser decreases, it could be
caused by low water pressure.
With the water filter removed, dispense 1 cup (237 mL) of
water. If 1 cup of water is dispensed in 8 seconds or less,
the water pressure to the refrigerator meets the minimum
requirement.
If it takes longer than 8 seconds to dispense 1 cup of
water, the water pressure to the refrigerator is lower than
recommended. See "Water Supply Requirements" or
"Problem Solver" for suggestions.
To Dispense Water:
1. Press the DISPENSE TYPE arrows on the dispenser control
panel, until "Water" is selected.
2. To dispense water, press a sturdy glass against the dispenser
pad OR press the WATER button. Hold the glass close to the
water dispenser spout to ensure that the water dispenses into
the glass.
A. Water dispenser spout
3. To stop dispensing, remove the glass from the dispenser pad
OR release the WATER button.
The Ice Dispenser
Ice dispenses from the ice maker storage bin in the freezer when
the dispenser pad is pressed. To turn off the ice maker, see "Ice
Maker and Storage Bin."
Your ice maker can produce both crushed and cubed ice. Before
dispensing ice, select which type of ice you prefer by pressing
the DISPENSE TYPE arrows.
The display screen indicates which type of ice is selected.
For crushed ice, cubes are crushed before being dispensed. This
may cause a slight delay when dispensing crushed ice. Noise
from the ice crusher is normal, and pieces of ice may vary in size.
When changing from crushed to cubed, a few ounces of crushed
ice will be dispensed along with the first cubes.
To Dispense Ice:
1. Make sure the desired type of ice is selected. To switch
between cubed and crushed, press the DISPENSE TYPE
arrows.
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
2. To dispense ice, press a sturdy glass against the dispenser
pad OR press the ICE button. Hold the glass close to the ice
guide to ensure that the ice dispenses into the glass.
A
IMPORTANT: You do not need to apply a lot of pressure to
the pad in order to activate the ice dispenser. Pressing hard
will not make the ice dispense faster or in greater quantities.
3. To stop dispensing, remove the glass from the dispenser pad
OR release the ICE button.
NOTE: Ice may continue to dispense for several seconds
after removing the glass from the pad. The dispenser may
continue to make noise for a few seconds after dispensing.
CRUSHED
WARNING
Cut Hazard
A. Ice guide
CUBED
A
15
Publicidad
