WERKU WK501400 Instrucciones Originales página 6

ENG
ORIGINAL
Risk Source / Cause Impact
Injection Atomized, high Severe
injury pressure stream injury or
of fluid
amputation
Explosion Static electricity Severe
or fire
or sparks injury
Hazaar- Hazaardous Severe
dous vapors from spray injury
vapors material
DESCRIPTION OF THE PRODUCT.
►
The gasoline airless hydraulic equipment has
been designed for the high pressure atomization
of liquid coating materials
to familiarize yourself with the gasoline airless
hydraulic equipment before use.
18
19
13
1
8
9
1. Transport handle.
2. Suction hose.
3. Return hose.
4. On/off switch.
5. Inlet filter.
6. Pressure regulator.
7. Prime/spray selector.
8. Airless gun.
9. Airless hose.
10. Hose connection.
11. Fuel filler cap.
12. Fuel tank.
13. Oil drain plug.
Preventative Can occur
measures during:
NEVER aim the Setup,
gun at any part of operation
the body
Use well ventilated Operation
area. Ground de
airless gun
Use well ventilated Operation
area. Use mask
►
Refer to this plan
16
15
14
11
12
4
17
21
6
22
20
10
2
3
7 5
English
14. Oil filler cap / Dipstick.
15. Muffler.
16. Air cleaner.
17. Starter grip.
18. Choke lever.
19. Fuel valve lever.
20. Pressure gauge.
21. Hydraulic pump valve control.
22. Transport pump turn handle.
USE INSTRUCTIONS.
►
Before starting up the gasoline airless hydraulic
equipment, we recommend that you carefully read
all of the instructions as indicated
all regulations regarding the prevention of accidents,
health and safety directives, laws and applicable
restrictions for work places
hydraulic equipment must only be used by persons
who have been instructed in its use and only for the
purposes for which it has been designed.
EARTH CONNECTION.
►
The gasoline airless hydraulic equipment must
be connected to earth while being used to protect
the operator from possible electrical shocks.
ENGINE WARNING.
►
Improperly maintaining this engine, or failure
to correct a problem before operation, can cause
a malfunction in which you can be seriously
►
hurt or killed Always perform a pre-operation
inspection before each operation, and correct any
►
problem Before beginning your pre-operation
checks, be sure the engine is level and the
engine switch is in the OFF position (1).
CHECK THE GENERAL CONDITION OF THE
ENGINE.
►
Look around and underneath the engine for signs
of oil or gasoline leaks
dirt or debris, especially around the muffler and
►
recoil starter Look for signs of damage
that all shields and covers are in place, and all
nuts, bolts, and screws are tightened.
CHECK THE ENGINE.
►
Check the fuel level
help to eliminate or reduce operating interruptions
►
for refueling Check the engine oil level
the engine with a low oil level can cause engine
►
damage Check the reduction case oil level on
6
►
Please respect
►
The gasoline airless
►
Remove any excessive
►
Check
►
Starting with a full tank will
►
Running