CONNECTIONS (CONNECTING EXTERNAL EFFECTORS, OUTPUT CONNECTORS/ABOUT MIDI CONNECTORS)
CONNECTING EXTERNAL EFFECTORS, OUTPUT CONNECTORS
Master output
This unit is furnished with balanced output MASTER 1 (supporting
XLR plugs), and unbalanced output MASTER 2 (supporting RCA
plugs).
Using the MASTER ATT switch, adjust the output level to match the
input sensitivity of the power amplifier used.
If the operating panel's STEREO/MONO switch is set to [MONO], the
master output will be a monaural combination of L+R channels.
Booth monitor output
This is a TRS output supporting Ø6.3 mm phone plugs. The sound
volume for this output is controlled by the BOOTH MONITOR level
dial, independently of the master output level setting.
Recording output
These are output connectors for recording, supporting RCA plugs.
Power amplifier
(RCA plug input connectors)
R
L
MASTER 2
POWER
OFF
ON
1GND
2HOT
3COLD
AC IN
Power amplifier
(XLR plug input connectors)
ABOUT MIDI CONNECTORS
See P. 19 regarding the functions of MIDI connectors.
6
<DRB1392>
En
Cassette deck
(analog input recording device)
L
R
SIGNAL GND
REC
PHONO
LINE
PHONO
L
L
L
CONTROL
R
R
R
DIGITAL
LINE
MASTER ATT
0dB
-3dB
-6dB
-12dB
R
L
ADD
CUT
MASTER 1
MIC SIGNAL
MASTER ATT
switch
Digital output
This is a coaxial digital output connector, supporting RCA plugs. The
sampling frequency can be set to 96 kHz/24-bit or 48 kHz/24-bit to
match the connected device.
External effector
Use a cable with Ø6.3 mm phone plugs to connect the DJ mixer's
SEND connectors to the effector's input connectors.
When using an effector with monaural inputs, connect only to the DJ
mixer's L channel output. In this way, the mixed L+R audio signal will
be sent to the effector. In the same way, use a cable with Ø6.3 mm
phone plugs to connect the DJ mixer's RETURN connectors to the
output connectors of the effector.
If the effector has only monaural output, connect to the DJ mixer's L
channel input only. The signal from the effector will be input to both L
and R channels.
When using an external effector, set the effect selector to [SND/RTN].
Sampling frequency selector switch
SIGNAL GND
LINE
PHONO
CD
LINE
L
L
CONTROL
CONTROL
R
R
DIGITAL
DIGITAL
LINE
CD
R
L
R
BOOTH
L
(MONO)
SEND
(TRS)
Power amplifier
(for booth monitor)
Digital input AV amplifier
(digital input recording device)
DIGITAL IN
CD
CONTROL
MIDI OUT
DIGITAL OUT
fs (Hz)
DIGITAL
CD
48 k
96 k
R
L
(MONO)
RETURN
External effector