Sauder Cannery Bridge Serie Instrucciones De Montaje página 13

Step 8
å
Fasten the SMALL EXTENSION RAILS (1) to the LEFT UPRIGHT (C). Use six 3/8" FLAT HEAD SCREWS (20).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the LEFT UPRIGHT. Turn a
SCREW into these holes.
å
NOTE: The SMALL EXTENSION SLIDES will be used later for the SMALL DRAWERS.
3/8" FLAT HEAD SCREW
(6 used in this step)
429414
20
C
www.sauder.com/service
1
1
Open end
Page 13