Sauder Cannery Bridge Serie Instrucciones De Montaje página 8

Step 3
å
Separate the LARGE EXTENSION SLIDES (4) from the LARGE EXTENSION RAILS (3) as shown in the upper diagram
below. Be prepared, the parts are greasy.
å
Fasten a LARGE EXTENSION RAIL (3) to the LEFT END (A). Use four 3/8" FLAT HEAD SCREWS (20).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the LEFT END. Turn a
SCREW into these holes.
å
NOTE: The LARGE EXTENSION SLIDES will be used later for the LARGE DRAWERS.
4
Push the black lever and pull the SLIDE from the RAIL.
Open end
Page 8
A
3
www.sauder.com/service
7
3
20
3/8" FLAT HEAD SCREW
(4 used in this step)
429414