Sauder Cannery Bridge Serie Instrucciones De Montaje página 21

Step 16
å
Fasten the LARGE EXTENSION RAIL (3) to the RIGHT UPRIGHT (D). Use four 3/8" FLAT HEAD SCREWS (20).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the RIGHT UPRIGHT. Turn a
SCREW into these holes.
å
NOTE: The LARGE EXTENSION SLIDES will be used later for the LARGE DRAWERS.
Open end
429414
D
3
www.sauder.com/service
20
3/8" FLAT HEAD SCREW
(4 used in this step)
Page 21