Sauder Cannery Bridge Serie Instrucciones De Montaje página 7

Step 2
å
Separate the SMALL EXTENSION SLIDES (2) from the SMALL EXTENSION RAILS (1) as shown in the upper diagram
below. Be prepared, the parts are greasy.
å
Fasten two EXTENSION RAILS (1) to the LEFT END (A). Use six 3/8" FLAT HEAD SCREWS (20).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the LEFT END. Turn a
SCREW into these holes.
å
NOTE: The SMALL EXTENSION SLIDES will be used later for the SMALL DRAWERS.
2
Push the black lever and pull the SLIDE from the RAIL.
Open end
429414
1
1
www.sauder.com/service
3/8" FLAT HEAD SCREW
A
7
1
20
(6 used in this step)
Page 7