Sauder Cannery Bridge Serie Instrucciones De Montaje página 25

Step 20 Step
å
Fasten the LARGE EXTENSION RAIL (3) to the RIGHT END (B). Use four 3/8" FLAT HEAD SCREWS (20).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the RIGHT END. Turn a
SCREW into these holes.
å
NOTE: The LARGE EXTENSION SLIDES will be used later for the LARGE DRAWERS.
3/8" FLAT HEAD SCREW
(4 used in this step)
429414
20
www.sauder.com/service
B
3
Open end
Page 25