Sauder Cannery Bridge Serie Instrucciones De Montaje página 24

Step 19
å
Fasten the SMALL EXTENSION RAILS (1) to the RIGHT END (B). Use six 3/8" FLAT HEAD SCREWS (20).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the RIGHT END. Turn a
SCREW into these holes.
å
NOTE: The SMALL EXTENSION SLIDES will be used later for the SMALL DRAWERS.
3/8" FLAT HEAD SCREW
(6 used in this step)
Page 24
20
B
www.sauder.com/service
1
1
Open end
429414