Sauder Cannery Bridge Serie Instrucciones De Montaje página 20

Step 15
å
Fasten the SMALL EXTENSION RAILS (1) to the RIGHT UPRIGHT (D). Use six 3/8" FLAT HEAD SCREWS (20).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the RIGHT UPRIGHT. Turn a
SCREW into these holes.
å
NOTE: The SMALL EXTENSION SLIDES will be used later for the SMALL DRAWERS.
Open end
Page 20
1
1
www.sauder.com/service
3/8" FLAT HEAD SCREW
(6 used in this step)
D
20
429414