Descargar Imprimir esta página

GreenWorks GD60LM46SP Manual Del Operario página 4

Ocultar thumbs Ver también para GD60LM46SP:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 19
EN
1
DESCRIPTION
1.1
PURPOSE
This machine is used for domestic lawn mowing. The
cutting blade must be approximately parallel to the
ground. All four wheels must touch the ground while
mowing.
1.2
OVERVIEW
Figure 1~13
Start button
1
Start handle
2
Self-propel drive lever
3
Upper handle
4
Lower handle
5
Grass catcher
6
Rear discharge flap
7
Height adjustment lever
8
Battery compartment flap
9
Mulch plug
10
Side discharge chute
11
Handle hole
12
Handle bolt
13
Handle nut
14
Handle pin
15
Grass catcher handle
16
Grass catcher hook
17
Door rod
18
Side discharge flap
19
Pivot
20
Safety key
21
Battery pack
22
Battery capacity indicator
23
Self-propel speed control
24
Blade bolt
25
Spacer
26
Blade
27
Battery release button
28
Turbo button
29
Headlight
30
Rubber edge guard
31
2
SAFETY
Make sure that you follow all safety instructions.
Refer to Safety Manual.
WARNING
English
3
INSTALLATION
Do not use accessories that are not recommended by
the manufacturer.
Do not put in the safety key or the battery pack until
you finalised the assembly of all the parts.
3.1
UNPACK THE MACHINE
Make sure that you correctly assemble the machine
before use.
If parts of the machine are damaged, do not use
the machine.
If you do not have all the parts, do not operate the
machine.
If parts are damaged or missing, contact the
service center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance
with local regulations.
3.2
UNPACKING AND HANDLE
ASSEMBLY
Figure 2
1. Place the mower upright in vertical position.
2. Remove the packing material from the cable.
3. Remove the rubber edge guard from the upper
handle.
4. Insert the upper handle into the lower handle.
5. Put the bolts through the holes and tighten with the
nuts.
Do not damage the cable while installing the upper
handle.
3.3
UNFOLD THE LOWER HANDLE
Figure 3
1. Pull up on the handle holes to release the lower
handles.
4
WARNING
WARNING
WARNING
WARNING
WARNING

Publicidad

loading

Este manual también es adecuado para:

Lmc404