GreenWorks GD24LM33 Manual Del Operario página 4

EN
1 SAFETY
Make sure that you follow all safety instructions.
Refer to Safety Manual.
2 DESCRIPTION
2.1 PURPOSE
This machine is used for domestic lawn mowing. The cutting
blade must be approximately parallel to the ground. All four
wheels must touch the ground while mowing.
2.2 UNPACK THE MACHINE
Make sure that you correctly assemble the machine before
use.
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
2.3 OVERVIEW
Figure 1~2
A. Upper control assembly
Handle switch
A-1
Start button
A-2
Upper handle
A-3
Upper handle knob
A-4
Upper handle bolt
A-5
B. Lower handle assembly
Lower handle
B-1
Lower handle screw
B-2
C. Grass catcher assembly
Grass catcher hook
C-1
Grass bag
C-2
WARNING
WARNING
WARNING
English
D. Main body
Battery compartment flap
D-1
Height adjustment lever
D-2
Rear discharge flap
D-3
Slot
D-4
Safety key
D-5
Battery release button
D-6
E. Mulch plug
3 INSTALLATION
Do not use accessories that are not recommended by the
manufacturer.
Do not put in the safety key or the battery pack until you
finalised the assembly of all the parts.
3.1 INSTALL THE LOWER HANDLE
Figure 3
1. Insert the lower handle into the frame holes.
2. Tighten the screws through the holes.
Do not make damage to the cables when you install the
handle.
3.2 INSTALL THE UPPER HANDLE
Figure 4
1. Align the holes in the upper handle and the lower handle.
2. Put the bolts through the holes.
3. Tighten the knobs onto the bolts.
4. Do the same operation on the other side.
3.3 INSTALL THE GRASS CATCHER
Figure 5
1. Open the rear discharge flap and hold it.
2. Hold the grass catcher by its handle and put the hooks
over the slots.
3. Close the rear discharge flap.
3.4 INSTALL THE MULCH PLUG
Figure 6
1. Remove the grass catcher.
2. Open the rear discharge flap and hold it.
3. Hold the mulch plug by its handle and fit it in the
discharge chute.
4
WARNING
WARNING
WARNING