Selco WF 330 Instrucciones De Uso página 41

3.5 Alarm codes
E01, E02 Temperature alarm
It is advisable not to switch off the equip-
ment while the alarm is on; the internal fan
will thus keep operating and will help to
cool the overheated parts.
E08 Blocked motor alarm
E10 Power module alarm
E13 Communication alarm
E19 System configuration alarm
E20 Memory fault alarm
E21 Data loss alarm
E40 System power supply alarm
E43 Coolant shortage alarm
E48 Wire out alarm
3.6 Rear panel
1 Gas fitting
2 Signal cable input (cable bundle)
3 Power cable input (cable bundle)
4 Positive power socket (MMA)
5 Cooling liquid inlet/outlet
3.7 Sockets panel
1 Torch fitting
Permits connection of the MIG torch.
2 External devices (Push/Pull)
3 Torch button connection
4 Cooling liquid connection
5 External devices (RC) (WF...Exclusive, RapiDeep
Exclusive, RapiDeep Steel - optional)
4 ACCESSORIES
4.1 General (RC) (WF...Exclusive, RapiDeep
Exclusive, RapiDeep Steel)
Operation of the remote control is activated when connected
to the Selco power sources. This connection can be made also
with the system power on.
With the RC control connected, the power source control panel
stays enabled to perform any modification. The modifications
on the power source control panel are also shown on the RC
control and vice versa.
4.2 RC 100 remote control
The RC 100 is a remote control unit designed to manage the
display and the adjustment of the welding current and voltage.
"Consult the instruction manual".
4.3 RC 180 remote control
This remote control unit makes it possible to change the output
current without interrupting the welding process.
"Consult the instruction manual".
4.4 RC 190 remote control
1
Allows continuous adjustment of the wire feed speed.
Allows the regulation of the welding current.
41