Olimpia splendid CALDO UP T Instrucciones Para El Uso Y El Mantenimiento página 38

If the set temperature is greatly higher than the ambient one (>3°C), the maximum
power heating function activates automatically (FAN and HIGH LEDs turned on).
If the set temperature is lower than the ambient one, the fan function activates auto-
matically (FAN LED turned on).
The set temperature can be changed at any moment during functioning.
3.4.e - Switching off delay mode
Press button
off delay mode; the TIMER LED on the appliance display turns on and the value
is shown.
Press the
which the unit will turn off.
Wait approximately 5 seconds without pressing any button: the delay will be set and
the TIMER LED will turn on the display.
After confirming the activation of the timer, it is possible to change the functioning mode at
any moment by pressing button
To cancel the delayed switching off, press button
by mode or, as an alternatively, repeat the setting procedure of the delay, entering the
value .
It is possible to set the desired delay until the hours numeric symbol flashes.
Once setting is over, after 5 seconds, the numeric value stop flashing and it
is automatically memorized. Is it's desired to further change the delay time,
it's necessary to repeat the operation from the beginning.
The weekly timer and this function can be set at the same time.
3.4.f - Flap functioning
When the appliance is on, pressing button
If it is desired to stop the flap in a certain position to direct the air flow, press button
again when the flap is oriented as desired.
Press the button one more time to start the flap oscillation again.
3.4.g - Weekly Timer mode
This mode can only be started when the appliance is in heating (it cannot be
started when the appliance is working as a fan only) or in set temperature
mode.
It is needed to set the current day and hour before using this function.
EN - 14
when the appliance is functioning to activate and set the switching
button once or more to set the desired delay (from 1 to 8 hours) after
. Once the set time has passed, the unit will turn off.
and the unit will switch to stand-
will cause the flap to start oscillating.