Publicidad
Idiomas disponibles
Idiomas disponibles
Installation:
The fan heater must be installed on a wall before operating. Don't try to use it without
installation.
The installation sequence of the fan heater is as follows:
1. Find a space to install the fan heater (See Figure ).
2. Drill two holes of the dimension of the expansible tubes ¢ - 8 mm - in the wall (See
Figure ) - D= 394mm
3. Insert the expansible tubes into the holes and tighten them with the screws
provided firmly.
NOTE: Fasten the screws tightly. Do not fasten the screw into the expansible tube
thoroughly; the length of the bare parts should be 10 mm.
4. Mount the fan heater to the wall . Make sure the two holes located on the back of
the heater do aim at the above two screws, then push the heater backwards to the
wall, and then downwards till the unit is stable.
The controls:
ON-OFF
- Press the ON -OFF switch to switch the appliance ON (I) or OFF (O).
=Power
=Mode Section
=Heating on half power (1000W)
=Heating on full power (2000W)
P = Weekly programming
=Open window Mode
°C = Setting temperature
= swing
= Timer (Turn-on/Turn-off)
Stand-by mode
2
Regular function operation
Temperature setting and
ErP function Confirm
Weekly time & window
open detection operation
EN
Publicidad
