HOMCOM 820-257 Manual De Instrucciones Y Montaje página 5

- Press again to switch off the appliance.
Stops by going into standby
(the fan stops 30 seconds after the stand-by).
TEMPERATURE CONTROL (ONLY by remote control)
- Press to switch on the appliance.
- Press + or - to set the setting temperature from 10°C to 49°C
(the light °C is on). If room temperature
15°C, setting temperature 25°C, the display as the picture
- Press to cancel the temperature setting
(the light °C is off) and to choose the heating on half power (
The heater working on full power when the room temperature is 4°C lower than the
setting temperature.
.The heater working on half power when the room temperature is between 0° and 2°C
lower than the setting temperature.
The heater switches off when the room temperature is higher than the setting
temperature. the fan working 30 seconds to make inside cool to protect component,
then fan stop, the unit enter into standby.
.The heater switches on again when the room temperature falls 2°C below the setting
temperature.
TURN-ON, TURN-OFF (by control panel and remote control)
Turn-on in stand-by mode:
- Press to set the appointment turn-on time in 1-12 hours (the
light is on).
.The display automatically decreases 1 hour for each hour passed.
When the appointment power-on time arrived, the product will
automatically turns on. The default setting temperature is 23°C.
.If not setting the setting temperature and weekly program, the unit
will automatically turn-off after continuous-by.
For example to set appointment turn-on time to 8 hours
Turn-offinrunning
Press to set the appointment turn-on time in 1-12 hours (the light
When the appointment power-off time arrived, the product will automatically turns off.
The default setting temperature is 23°C
For example to set appointment turn-off time to 8 hours
mode
4
) or full power (
is on)
EN
).