♦
Undo the union nut
it from the spray unit
♦
Fit the desired nozzle
head
.
♦
Screw the union nut
unit
.
Filling with spray material
♦
Unscrew the paint cup
♦
To work on a horizontal object, place the riser
pipe
in front, facing the nozzle head
work overhead, place the riser pipe
back, facing the motor unit
♦
Fill the paint cup
screw it firmly onto the spray unit
Switching the appliance on/off
Working methods
♦
Hold the spray gun at a constant distance from
the object. The ideal spraying distance is
approx. 15 cm.
♦
Work out the best settings by carrying out a
test.
♦
Do not switch the appliance on/off over the
spray surface. Rather, start/end the spraying
process approx. 10 cm from the spray surface.
Switching on
♦
To switch on, pull the trigger
pressed in.
Switching off
♦
To stop spraying, simply release the trigger
Adjust spray pattern
Set the spray rate
♦
Turn the spray volume adjusting wheel
the desired position:
(–) = minimum spray rate
(+) = maximum spray rate
NOTE
►
We recommend starting at the minimum
setting.
│
GB │ IE
■
8
completely and remove
.
onto the nozzle
back onto the spray
from the spray unit
at the
.
with the spray material and
.
and keep it
to
Selecting a jet type
♦
Undo the union nut
♦
Turn the protruding parts of the nozzle head
so that they point to the desired symbol on the
spray unit
The appliance has the following settings:
▯ round jet
vertical flat jet
.
horizontal flat jet
. To
♦
Re-tighten the union nut
Maintenance and cleaning
WARNING! RISK OF INJURY! Always
switch the appliance off and remove
the battery before carrying out any
work on the appliance.
ATTENTION!
►
Never immerse the paint spray gun completely
in solvent.
NOTE
►
Thorough cleaning after every use is very
important for safety and operation.
Otherwise, the needle could get blocked and
proper operation of the appliance cannot be
guaranteed.
■
Wear suitable gloves when cleaning.
■
After every use, squirt water through the
appliance.
♦
To clean the spray unit
.
nozzles
the supplied cleaning brush
needle
or cleansers which can damage plastic.
♦
Store the device only in dry interior rooms.
.
.
.
, nozzle head
and the spray holes inside, use
, cleaning
or a cloth. Never use petrol, solvents
PFSA 20-Li C3
,